Mounting on bikes with mounting holes

I LOCK IT is attached to the seat stays of your bike. I LOCK IT offers three mounting holes for the best compatibility.

Through these holes I LOCK IT can be mounted at the optimum height for your bike.

Attention: An installation of I LOCK IT is only allowed on the rear wheel. Mounting it on motorcycles such as motor scooters, motorcycles or s-pedelecs (pedelecs with support up to 45km|h) is not allowed.


  • If your bike already has mounting holes for the frame locks, follow the instructions below. If your bike does not have mounting holes for frame locks, please visit our page on installing I LOCK IT with our installation adapters.
  • Most city, trekking and e-bikes have mounting holes for frame locks. On some models these holes may be protected by plastic covers. These covers must be removed before instaling I LOCK IT.



Follow these steps to install I LOCK IT:

  1. Pass I LOCK IT over your fender | tire.
  2. Mount I LOCK IT to the mounting holes in the bicycle-frame. Hand-tighten (3Nm) the supplied screws with an Allen key.


In this short tutorial we show you how to mount I LOCK IT on your bike.

We are here

Questions about I LOCK IT?

We will call you back.

Use our call back service!

E-Mail Support

Write us an e-mail